CX-30 / Everyday controls

Mazda CX-30: How to use rain sensing windshield wipers

2 min readReviewed 25 October 2026

2025US

CHECK YOUR CAR2025 Mazda CX-30 US-market digital owner manual; only the equipment and controls described here.

Touching the rain-sensor area can trigger wiping. Water-repellent coatings, dirt and ice can affect detection.

THE QUICK ANSWER

Select AUTO on an equipped wiper lever and adjust sensitivity with its ring. Use LO or HI for continuous manual wiping when conditions require direct control.

Step by step

1Select the correct modeUse AUTO only on a rain-sensor-equipped car; a lever marked INT uses intermittent operation instead.
2Adjust the responseRotate the sensitivity switch to the marked higher or lower setting while monitoring the wiping response.
3Use manual control when neededSelect LO or HI if automatic wiping is unsuitable. Put the lever OFF before cleaning or clearing ice near the sensor.

Tick steps as you go. Your progress stays in this tab.

Common questions

How do I request just one wipe?+

Move the lever to MIST and release it immediately.

SOURCES & SCOPE

Where this guide comes from

Written from the official references below, reviewed on 25 October 2026. This is a source-based guide, not a claim of hands-on vehicle testing.

Mazda USA — 2025 CX-30 owner manual ↗

Read our editorial policy

Ready for the next small job?Explore all guides

Mazda CX-30: How to use rain sensing windshield wipers

Step by step

Common questions

Where this guide comes from

More help for your car.

Mazda CX-30: How to switch on the wiper deicer

Mazda CX-30: How the rear wiper and washer controls work