How to reset a Volvo EX60 power window that will not close correctly
A window that stops short and a window that closes then reopens are not treated as the same calibration problem in the EX60 manual. Identify the behavior before attempting the documented reset.
Checked against the US EX60 2027 manual on 27 October 2026. Match the controls to your car and use its current in-car instructions if a software update changes the screen.
Use the driver-door switch to close the affected window with a light pull, then quickly and lightly pull the switch twice. Check operation afterwards. A window that closes and reopens because of an upward offset needs workshop recalibration.
Keep the opening clear
Pinch protection may not work correctly while calibration is lost. Keep hands and objects clear and do not test protection using a body part. If auto-close reaches the top and then opens again, the manual identifies an offset that you cannot recalibrate yourself.
Reset an eligible window
Tick steps as you go. Your progress stays in this tab.
When to stop repeating the reset
If the problem remains, contact an authorized Volvo workshop. The source distinguishes an upward calibration offset that requires workshop help; do not keep applying a reset from an older Volvo as an alternative.
Common questions
Is a long switch hold part of this procedure?+
The cited EX60 instructions specify two quick, light pulls after closing, not a timed hold.
What does closing and immediately reopening mean here?+
The manual describes that as a possible upward offset, which needs authorized workshop recalibration.
SOURCES & SCOPE
Where this guide comes from
Written from the official references below. Reviewed on 27 October 2026. This is a source-based guide, not a claim of hands-on vehicle testing.
Read our editorial policy