7X / Displays & settings

How to reboot the Zeekr 7X centre and driver displays

A documented display restart can be useful when the interface is unresponsive. It cannot diagnose repeated black screens or replace investigation of a recurring fault.

3 min readReviewed 27 October 2026

2025Zeekr 7X export software; equipment dependentEurope

CHECK YOUR CAR2025 Zeekr 7X · Europe English online manual · Long Range RWD reference

Checked against the official European English MY2025 7X online manual on 27 October 2026. China-market apps, hardware and OTA versions differ. Match your car’s display and equipment; the Chinese report supplies context, while the manufacturer manual supplies the procedure.

THE QUICK ANSWER

With the car safely parked, hold the thumbstick on the left side of the steering wheel and the scroll wheel on the right side together for ten seconds to reboot the displays.

Chinese owner report: context, not a diagnosis

A forum report summarises repeated black-screen freezes after an upgrade and says a repair was performed. This is an individual report or discussion, not evidence of a widespread defect. The checks below concern the European export car; they do not establish what caused the Chinese owner’s symptom.

Before you start

Stop safely and put the car in P before troubleshooting. If warnings, missing driving information or an unsafe vehicle condition are involved, seek Zeekr assistance.

Follow the export-car controls

1Identify both controlsLocate the left steering-wheel thumbstick and the right steering-wheel scroll wheel. They are different controls, so check their positions before pressing.
2Hold togetherPress and hold both controls at the same time for ten seconds, following the official display-reboot procedure.
3Check the returned interfaceAllow the displays to restart, then check their normal information and any messages before considering the car ready for use.

Tick steps as you go. Your progress stays in this tab.

Check the result

Record what was happening and the installed software version if the symptom returns. The Chinese report says a vehicle was repaired; it does not show that a restart permanently fixes the same symptom. A display that stays unresponsive, or repeated failures, warrants support.

Common questions

Is this a factory reset?+

The cited procedure is a display reboot. It is not the separate restore-settings procedure.

Should I repeat it whenever the screen fails?+

Repeated failures need diagnosis. Note when they occur and contact Zeekr instead of treating a restart as a permanent repair.

SOURCES & SCOPE

Where this guide comes from

Operating steps are checked against manufacturer documentation; Chinese owner discussions are labelled as anecdotal reports. They identify questions, not the prevalence or cause of a fault. Reviewed on 27 October 2026. This is a source-based guide, not a claim of hands-on vehicle testing.

Read our editorial policy

Ready for the next small job?Explore all guides