B10 / Displays & settings

How to check and install a Leapmotor B10 software update

An owner forum can flag a symptom but cannot tell you which update is approved for your vehicle. Use only the upgrade offered through the car’s official system.

3 min readReviewed 27 October 2026

2025 manualB10 BEV infotainment / fitted equipmentAustralia · export specification

CHECK YOUR CARB10 BEV · Australia English documentation · June 2025 manual · export equipment only

Checked against the English BEV manual linked below. China-market reports identify the owner question; they do not establish an export defect, a recall or a guaranteed fix. Match the handbook and equipment in your car, and follow current on-screen instructions where software differs.

THE QUICK ANSWER

Check Settings → System → General for an update offered to your B10. Before installation, select P, apply the parking brake and have at least 20% battery. Read and accept the displayed instructions, then allow the upgrade to complete without driving.

The China-market owner report

The Chinese B10 restart discussion includes suggestions to update software. It provides no confirmed export release that fixes the issue; installing an offered update is maintenance, not a promised repair.

Before you start

Leave enough time for the vehicle to be unavailable. The manual warns that windows, locks and other functions may be temporarily unavailable and that the screens restart during installation. Do not leave anyone dependent on those controls inside.

What to check

1Check the official offerOpen Settings → System → General. Note the installed version and any upgrade notification supplied for your car.
2Meet the installation conditionsPark in P, apply the parking brake and check the traction battery is at least 20%. Follow any additional conditions shown on the car.
3Read before confirmingReview the upgrade notice and agree only when ready for the vehicle to be unavailable. Use the offered confirmation to begin.
4Wait and verify completionAllow screen restarts during installation. After completion, confirm the vehicle returns normally. If it reports a failed upgrade or cannot enter READY, contact an authorised dealer.

Tick steps as you go. Your progress stays in this tab.

Check the result

The installed official version is the useful outcome. If the original problem persists, retain its evidence for service rather than seeking Chinese firmware files, unofficial packages or a downgrade.

Common questions

Will this fix the forum’s restart problem?+

No specific fix is established by that discussion. Check official release information for your vehicle.

Why does the screen restart several times?+

The manual describes multiple screen restarts as part of the normal upgrade process.

SOURCES & SCOPE

Where this guide comes from

Operating steps are checked against manufacturer documentation; Chinese owner discussions are labelled as anecdotal reports. They identify questions, not the prevalence or cause of a fault. Reviewed on 27 October 2026. This is a source-based guide, not a claim of hands-on vehicle testing.

Read our editorial policy

Ready for the next small job?Explore all guides