C10 / Maintenance

How to check the Leapmotor C10 tyre-pressure display and warnings

A China-market retrofit story does not tell you which tyre-monitoring equipment your export C10 has. Start with its Vehicle State screen and the manual supplied for your car.

3 min readReviewed 27 October 2026

2025 manualC10 BEV infotainment / fitted equipmentAustralia · export specification

CHECK YOUR CARC10 BEV · Australia English documentation · June 2025 manual · export equipment only

Checked against the English BEV manual linked below. China-market reports identify the owner question; they do not establish an export defect, a recall or a guaranteed fix. Match the handbook and equipment in your car, and follow current on-screen instructions where software differs.

THE QUICK ANSWER

Open Vehicle State from the App Centre to view vehicle-health information and highlighted tyre warnings. Compare the tyre-monitoring information with your own handbook; do not buy a China-market sensor upgrade because a forum car received one.

The China-market owner report

A Chinese C10 owner describes dealer installation of a tyre-pressure display and notes a difference between app and car readings. That is a specific domestic-market retrofit report, not an installation instruction or export entitlement.

Before you start

The checked export manual documents TPMS warnings and Vehicle State. A displayed warning needs a physical tyre check; the screen is not a substitute for checking cold pressure against the vehicle placard.

What to check

1Open the health displayWith the vehicle safely parked, open App Centre and then Vehicle State. Read the health information and any highlighted tyre.
2Read the precise warningDistinguish a pressure warning from a missing or abnormal sensor signal. Note which wheel and message are shown.
3Check the tyre condition and specified pressureInspect for visible damage or loss of air. Check pressure against the vehicle’s own cold-pressure label; avoid using another market’s pressure number.
4Report missing data or a persistent warningIf the display does not match your handbook or a warning remains after proper tyre attention, ask the dealer to check the fitted system and sensors.

Tick steps as you go. Your progress stays in this tab.

Check the result

You should identify the warning and the affected tyre without assuming that new sensors are required. A damaged or rapidly deflating tyre needs safe roadside assistance rather than a software reset.

Common questions

Does every C10 qualify for the Chinese retrofit?+

No. The forum report does not establish equipment or programmes outside China.

Should I reset a warning without measuring pressure?+

No. Check the actual tyre and the specified cold pressure first.

SOURCES & SCOPE

Where this guide comes from

Operating steps are checked against manufacturer documentation; Chinese owner discussions are labelled as anecdotal reports. They identify questions, not the prevalence or cause of a fault. Reviewed on 27 October 2026. This is a source-based guide, not a claim of hands-on vehicle testing.

Read our editorial policy

Ready for the next small job?Explore all guides